All chassis parts before assembly 1.JPG |
Bare chassis front view 2.JPG |
Bare chassis with rollbar.JPG |
Bare wheel.JPG |
Bonding in rear carrier brackets with E-120HP.JPG |
Bonding the uprights.JPG |
Carbon Fiber Tube Stiffener bonded in.JPG |
Chassis assembled on ground 2.JPG |
Chassis assembled on ground 7.JPG |
Chassis assembly using E-120HP.JPG |
Chassis with A-arms footbox and uprights.JPG |
Clamping down front section for cure.JPG |
Coolant overflow canister tucked in tube caps bonded on.JPG |
Detail Nomex core floor at pedal box.JPG |
Dispensing E-120HP epoxy at bulkhead.JPG |
Fitting steering rack before bonding brackets.JPG |
Front corner full test fit.JPG |
Front Shock mount bonded on.JPG |
Front Shock mounts bonded on.JPG |
Front suspension bonded to tubes.JPG |
Holding front chassis section 2.JPG |
Holding up the front chassis section.JPG |
Inside - Between the front bulkheads.JPG |
Inside the front of the chassis during assembly.JPG |
Marty & Dushan Chassis assembly.JPG |
Marty during chassis bonding.JPG |
Measuring for correct fit before continuing assembly.JPG |
Measuring for final assembly.JPG |
Middle-Front Carbon Fiber Tube Stiffener bonded in.JPG |
Pedal assembly.JPG |
Pedal box bonded inserts.JPG |
Pedal box bonded to footbox.JPG |
Rear corner rear view.JPG |
Rear engine mount lower before upper after bonding.JPG |
Rear shock mount-tube stiffener test fit before bonding in.JPG |
Steering block bonded to bulkhead crossmember.JPG |
Steering gear bonded into housing.JPG |
Steering rack mount bonded on.JPG |
Steering tie rod bonded to rack gear.JPG |
The front chassis section assembled using E-120HP.JPG |
The front chassis section before assmebly.JPG |
The front chassis section during assemlby.JPG |
Travis adding the rear bulkhead sub-assembly.JPG |
Travis dispensing the bonding epoxy Loctite E-120HP.JPG |
Upright - Inside both halves at once.JPG |
Upright halves bonded together.JPG |
V35 Chassis.jpg |
Wheel reinforcer Close up.JPG |
Wheel reinforcer.JPG |
Wheel with reinforcer bonded in.JPG |
