180 grit sandpaper Small.JPG |
3M heat cure carbon sheared before bond.JPG |
3M Scotch-Weld 2158.JPG |
3M Scotch-Weld 2214 Pic 2.JPG |
3M Scotch-Weld DP460.JPG |
A-arm test 3.jpg |
Acetone after sanding.JPG |
Aluminum fails before bond.JPG |
Aluminum test strips with sanded end 2.JPG |
Bonding Samples 5.JPG |
Carbon Fiber test strips with sanded end 2.JPG |
Chris recording test data.JPG |
Chris setting up the jaws.JPG |
Defined bond area after failure.JPG |
During Mixture-Ratio-Variation Testing.JPG |
E120-HP.jpg |
Gun with seperate tube.jpg |
_JPG.jpg)
Loctite E-120HP (Pic 2).JPG |
_JPG.jpg)
Loctite H4500 (Pic 2).JPG |
_JPG.jpg)
Loctite Hysol 9430 (Pic 2).JPG |
Lower Layer of testing setup.JPG |
Middle Layer of testing setup.JPG |
Mike watching test run.JPG |
Mike's data for mix ratio variation.JPG |
Sample clamped in 2.JPG |
Sample Clamped in 3.JPG |
Set of Mixture-Ratio-Variation Test Strips.JPG |
Set of test strips before bonding 2.JPG |
Stack of Aluminum Test Strips Prepped for Bonding.JPG |
Thickness of Aluminum test strips.JPG |
Thickness of carbon fiber test strips.JPG |
Touch & Prep.JPG |
Travis and Chris.JPG |
Travis setting up a test run 2.JPG |
Upper Layer of testing setup.JPG |
V35 Chassis.jpg |
Variations of Cure-Temperature set.JPG |
